Bowflex 001-6961 manual Attach the Chest Bar with Pulleys to the, Main Assembly, Assembly Guide

Assembly Guide
Step 4 - Attach the Chest Bar with Pulleys to the	Figure 4
Main Assembly
Locate the following items:		Chest Bar
	K
• From Step 3 - Main Assembly		Brackets
• Item #6 - Chest Bar w/ Pulleys - Do not unwrap cables!		6
• Item #K - (2) 3/8" X 5" Button Head Screws
• Item #N - (4) 3/8" Washers
• Item #O - (2) 3/8" Nylock Nuts	N
Line up the bolt holes in the brackets on the Chest Bar
with Pulleys (Item #6) with the lowest bolt holes on the
Lower Lat Tower, as shown in Figure 4. Pulleys should be
oriented forward.		O
Place (2) 3/8" Washers (Item #N) over the end of (2) 3/8” X		Base Platform/
5" Button Head Screws (Item #K) - one washer per screw.		Lower Lat Tower
Insert the screws through the lined up holes in the Chest		Assembly
Bar with Pulleys and the Lower Lat Tower, and secure each
screw by placing (1) 3/8" Washers and (1) 3/8" Nylock Nuts
(Item #O) over the end of each screw.
Completely tighten hardware installed during Step 4.

Step 5 - Attach the Seat Bracket to the Seat Pad

Locate the following items:

•Item #7 - Seat Pad

•Item #8 - Seat Bracket

•Item #C - (4) 5/16" X 3/4" Button Head Screws

•Item #M - (4) 5/16" Washers

Place the Seat Pad (Item #7) on the floor, cushion-side down. Position the Seat Bracket (Item #8) so the cut-out is toward the angled edge of the Seat Pad. Align the four holes in the Seat Bracket with the four holes in the Seat Pad.

Place (4) 5/16"Washers (Item #M) over (4) 5/16" X 3/4" Button Head Screws (Item #C) - one over each screw, and use those screws to secure the Seat Bracket to the Seat Pad.

Completely tighten hardware installed during Step 5.

Figure 5
	C
M	8
	Cut-out
7
	Angled
	Edge

7