Bowflex 001-6961 Attach the Rear Leg to the Seat Rail, Rail Pull Pin, Assembly can move freely

Assembly Guide
Step 8 - Attach the Rear Leg to the Seat Rail	Figure 8
Locate the following items:
• From Step 6 - Seat Rail Assembly
• From Step 7 - Rear Leg Assembly
• Item #J - (1) 3/8" X 4 1/4" Button Head Screw			End
• Item #N - (2) 3/8" Washers
			Bracket
• Item #O - (1) 3/8" Nylock Nut
• Item #Q - (2) Bolt Covers			O
Undo the twist ties from the Pivot Bushings on the end of the Rear	Rail
	Assembly
Leg Assembly (from Step 6), but do not remove the Bushings.		N
Note: When attaching the Rear Leg Assembly (from Step 7) to
the Seat Rail Assembly, rotate the Rear Leg forward (as shown			Middle
in Figure 8b), to allow the Leg Latch to engage with the Seat
		J	Hole
Rail Pull Pin.
Align the holes on the End Bracket of the Seat Rail Assembly with
the middle holes on the Rear Leg Assembly, (see Figure 8).		Rear Leg
		Assembly
Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X 4 1/4"
Button Head Screw (Item #J). Insert the screw through the lined
up holes and then loosely secure on the opposite side by placing (1)
3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over the end.
Do not over-tighten hardware from Step 8.	Figure 8b
	Rail
		Leg Latch
Note: Tighten the nylock nut enough that the threads of the screw	Assembly
extend through the nylock nut, but loosely enough that the Leg
Assembly can move freely.

At this time, place (1) Bolt Cover (Item #Q) over the Nylock Nut installed during Step 8, place 1 bolt cover over the Nylock Nut going through the rear leg pulley.

Once you have completed Step 8, rotate the Rear Leg back until it engages the Seat Rail Pull Pin.

Seat Rail Pull Pin

Rear Leg

9