5505 Guest IP Phone Administration Guide

Table 1: 5505 IP Phone Troubleshooting (continued)

Problem/Message

Cause

Solution

 

 

 

 

 

 

Incorrect PIN is

PIN is not correct.

Re-enter the wireless PIN in the User Device

displayed on the

 

Configuration form and try to pair again.

handset.

 

 

 

 

 

 

 

 

 

Register handset is

The handset is not paired with the

Pair the handset with the base. See “Pairing the

on the display.

base.

5505 Cordless Handsets” on page 12.

 

 

 

 

 

Registration failed

Base is powered off.

Turn on the base.

 

is displayed on the

Base is not in pairing mode.

Put the base in pairing mode. See “Pairing the 5505

handset.

 

Cordless Handsets” on page 12.

 

 

Handset is out of range.

Place the handset closer to the base.

 

Ensure that the handset variant matches the base.

 

The handset variant (NA or UK)

 

doesn’t match the base.

 

 

 

Handset does not

The handset is not turned on.

Press the end call key for approximately 5

get dial tone.

 

seconds or place the handset in the base.

 

 

Charge or replace the batteries.

 

 

If the handset is turned on

A handset is in use.

 

 

 

 

 

 

 

The phone may be stuck booting up. See “Phone

 

 

State During Startup and First Registration” on

 

 

page 42 for its current state.

 

 

 

 

 

 

The handset does

The ringer may be silenced.

Press and hold the * key

 

to turn the ringer

not ring.

 

on.

 

 

 

 

 

 

 

 

 

 

DHCP failures -

Unable to obtain an IP address or

Check the network connectivity.

 

Waiting for DHCP

incorrect DHCP settings on the

 

 

 

is displayed on the

server.

Reconfigure the DHCP settings.

 

handset for more

 

 

 

 

than 5 minutes.

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 2 of 2

 

 

 

 

 

Table 2: Phone State During Startup and First Registration

LED Behavior

Mode

Solution

 

 

 

Speakerphone flashing for more

LLDP & IP provisioning

Check the network connectivity.

than 5 minutes

 

Reconfigure the DHCP settings.

 

 

 

 

 

Mute flashing for more than 5

Upgrading firmware - l2 Boot, main

Re-install the firmware on MCD

minutes

and recovery

and reboot the 5505 phone.

 

 

 

Messages flashing for more than 5

Main startup and CVM firmware

Reboot the phone.

minutes

upagrade

 

 

 

 

No LED flashing

Successful boot up

 

 

 

 

42

Page 48
Image 48
Mitel 5505 manual Phone State During Startup and First Registration