Assembly Guide
Step 16 - Attach the Upper Lat Tower to the Lower
Locate the following items:
•From Step 15 - Upper Lat Tower Assembly
•From Step 14 - Main Assembly
•Item #E - (6) 3/8" X 3/4" Button Head Screw
•Item #N - (6) 3/8" Washers
Carefully insert the end of the Upper Lat Tower into the open end of the Lower Lat Tower. Align the holes on the Upper Lat Tower with the holes on the Lower Lat Tower.
Place (6) 3/8" Washers (Item #N) over the ends of (6) 3/8" X 3/4" Button Head Screws (Item #E) - one washer per screw. Thread the screws into the aligned holes, as shown in Figure 16.
Completely tighten hardware installed during Step 16.
Figure 16
Upper Lat
Tower
N
E
Lower Lat
Tower
Step 17 - Attach the Rod Box with Power Rods® to the Rod Box Frame
Locate the following items:
•Item #24 - Rod Box Frame
•Item #25 - Rod Box with Power Rods®
•Item #B - (3) #10 X 1" Phillips Head Screws
•Item #L - (3) 1/4" Washers
Place the Rod Box Frame (Item #24) and Rod Box with
Power Rods® (Item #25) onto one side as shown in Figure 17. Slide the Rod Box with Power Rods® into the Rod Box Frame until the Rod Box is completely seated in the Rod Box Frame.
Place (3) 1/4" Washers (Item #L) over the ends of (3) #10 X 1" Phillips Head Screws (Item #B) - one washer per screw. Insert the screws through the slot on the Rod Box Frame and thread into the holes in the Rod Box with Power Rods®.
Completely tighten hardware installed during Step 17.
Figure 17
24
L
B
Slot
25
15
