Assemble the Leg Extension Seat | Bowflex 001-6961 manual

Assembly Guide

Step 13 - Assemble the Leg Extension Seat

Locate the following items:

•Item #19 - Leg Extension Seat Pad

•Item #21 - Leg Extension Seat Support Tube

•Item #C - (4) 5/16" X 3/4" Button Head Screws

•Item #M - (4) 5/16" Washers

Place the Leg Extension Seat Pad (Item #19) cushion-side down. Align the holes in the Leg Extension Seat Support Tube (Item #21) with the holes on the underside of the Seat Pad.

Place (4) 5/16" Washers (Item #M) over (4) 5/16" X 3/4" Button Head Screws (Item #C) - one over each screw. Insert the screws through the aligned holes, and tighten.

Completely tighten hardware installed during Step 13.

Figure 13

Rail

Bracket

Seat

Curved

Edge

Page 15

Image 15

Bowflex 001-6961 manual Assemble the Leg Extension Seat

Contents

Bowflex Sport Home Gym Assembly Instructions Table of Contents Safety Precautions Home Gym Get to Know Your Machine Basic Assembly Principles Tools You Will Need Hardware Guide Assembly Guide Attach the Lower Lat Tower to the Base PlatformAttach the Base Legs to the Base Platform Completely tighten hardware installed during Step Attach the Squat Platform to the Main Assembly Insert the screws through the lined up holes in the Chest Attach the Chest Bar with Pulleys to Main AssemblyAttach the Seat Bracket to the Seat Pad Button Head Screws Item #K one washer per screw Attach the Rear Leg to the Rear Leg Cross Tube Attach the Seat Rail to the Seat Assembly Do not over-tighten hardware from Step Assembly can move freelyAttach the Rear Leg to the Seat Rail Rail Pull Pin Attach the Seat Rail to the Main Assembly Rail Assembly can move freelyDo not over-tighten the hardware from Step 10a Attach the Leg Extension Pivot Tube Holes in the Leg Extension and cable end. Place 1 3/8 Attach Leg Cable to the Leg ExtensionSlide the hooked end of the Leg Cable beneath the Leg Thread the screw through Assemble the Leg Extension Seat Attach the Leg Extension Seat to the Main Assembly Attach the Lat Cross Bar to the Upper Lat TowerPlace 2 3/8 Washers Item #N over the ends Attach the Upper Lat Tower to the Lower Attach the Rod Box with Power Rods to the Rod Box Frame Attach the Faceplate to the Main Assembly Attach the Rod Box Frame to the Lat TowerBe tightened during Step #A, as shown in , attaching one side at a time Attach the Faceplate Back PanelsTighten Lower Bolt on the Seat Bracket Them until the panels meet in the center Repeat for remaining Chest Pulley Rod Cable Attach the Bench to the Seat AssemblyRoute the Rod Cables Locate the following items Repeat for remaining Squat Cable Route the Lat CablesRoute the Leg Cables Route the Squat Cables Offices in the United States International Offices Page Sport