Assembly
Do not connect the machine to power source until completely assembled. Read and understand the entire manual.
Securing Machine to Stand
The mortiser should be secured to the stand with four M8 x 45 hex cap screws and M8 lock washers (provided) using the holes in the base. Make sure there is enough room on each side of the mortiser for the size stock you plan to use.
Wooden Table
Referring to Figure 6:
1.Place the wooden table (A) in position on the slide (B).
2.Secure with two Phillips head screws provided (C).
Operating Handle
Referring to Figure 7:
1.Fasten operating handle (A) to the hub (B) and tighten with a 14mm
2.Raise mortising machine head to the up position by moving the operating handle
(A) up.
Note: The handle assembly is
Figure 6
Figure 7
10
