FEATURES
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°, 11.25°,15°, 22.5°, 31.62°,and 45°. The 0°,11.25°,15°,22.5°,31.62°,and 45° positive stops have been provided on both the left and right side of the miter table.
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter saw at desired bevel angles. Positive stop adjustment screws have been provided on each side of the saw arm. These adjustment screws are for making fine adjustments at 0° and 45°. Using the bevel override feature allows up to 48° for bevel cuts.
ELECTRIC BRAKE
An electric brake has been provided to quickly stop blade rotation after the switch is released.
MITER FENCE
The miter fence on your compound miter saw has been provided to hold your workpiece securely against when making all cuts. The sliding miter fence on the left side is also larger providing additional support.
The
MOUNTING HOLES
See Figure 6.
Your compound miter saw should be mounted to a firm supporting surface such as a workbench. Four bolt holes have been provided in the saw base for this purpose. Each of the four mounting holes should be bolted securely using 3/8 in. (10 mm) machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench. Tighten all four bolts securely.
The hole pattern is for an 18 in. x 24 in. (457 mm x 610 mm) workbench. Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating.
WARNING:
The operation of any saw can result in foreign ob- jects being thrown into your eyes, which can result in severe eye damage. Before starting power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend wide vision safety mask for use over eyeglasses or standard safety glasses with side shields.
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of
WARNING:
To avoid serious personal injury, always assure saw is fully supported and securely attached to a level work surface.
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
50
45
40
35 |
|
31.625 | 30 |
|
25 | 22.5 | 20 |
|
|
|
|
|
| |
|
| 15 | 5 | 0 |
SAW BASE
WARNING:
Do not attempt to modify this tool or create acces- sories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
|
|
| 50 |
|
|
| 45 |
|
|
| 40 |
|
| 35 | MOUNTING SURFACE |
| 30 |
| |
25 |
|
|
|
20
15 5
Fig. 6
12
