RIDGID OL50145MW Installing the dipstick, Checking the oil, Installing the SEMI-PNEUMATIC Tire

ASSEMBLY

installing the dipstick

See Figure 4.

The air compressor has a label installed between the oil fill hole and a travel cap. Before using the unit the first time, remove travel cap and label and insert supplied dipstick. Make sure to add oil before first use. See Checking the Oil before first time operation.

checking the oil

See Figures 4 - 5.

Always check the oil when the unit is sitting on a level surface and before first use.

nInsert the dipstick into the oil fill hole completely. Remove the dipstick and check the oil level.

nMake sure the reading is between the MIN and MAX reference levels on the dipstick.

NOTE: Never let the oil drop to a level lower than MIN. Maximum level is reached when the oil reaches the MAX level reference on the dipstick.

nReinsert the dipstick securely into the oil fill hole.

To add oil:

nRemove the dipstick.

nUsing a funnel, carefully pour oil into the oil fill hole. Refill only with synthetic oil SAE 5W50.

NOTE: Avoid using too much oil. Ensure that the level of the oil does not exceed the maximum reference level on the dipstick.

nReinsert the dipstick securely into the oil fill hole.

installing the SEMI-PNEUMATIC TIRE

See Figure 6.

Insert supplied axle rod through hole in semi-pneumatic tire hub, centering the tire between the two center holes in the axle rod.

Insert washers onto axle rod on either side and slide hitch pins through both holes on either side of semi-pneumatic tire to secure semi-pneumatic tire to the center of the axle rod.

Insert tire rod (with semi-pneumatic tire installed) end through metal bracket on the front of the air tank.

Insert the other axle rod end through metal bracket on the opposite side.

Align the holes on the axle rod end with the slots in the metal brackets and install supplied screws through the lined up holes.

dipstick

ON	OFF	O
	I

ON

	ADD
	add
		oilOIL
			and
abastecer	appointAPPOINTBinsertEFORE
	DÉMARRAGE
ABASTECERde		d’huile . dipstickSTART
DE	d’huile
ARRANCARLOaeite				Retirer		before
			D’HUILE			.
antes	premieret					Remove
	DE			insérer
de y
		.				start
					PREMIER		cap,
		ACEITEdémarrage					up
		Retire			bouchon,jauge		.
	arrancarlointroduzcala				.
			.	ANTES
				latapa,
				tap
					a,

	label
oil fill hole	Fig. 4
reference	dipstick
level marks

MAX

						max reference mark				Fig. 5
										SCREW
MPRESSORCON
MBA		ALUBRICACION
				TM						HITCH PIN
UFE	-	T	O		DE
4			K
			S		ACI
	6		-		ETE
40	80		R
			I
			T
		120	E
bar		160
					QUE		-	TA
					N			NK
					A				-
					T	4		6	R
									E
								80	S
									V
									E
					2	40			O
									I
								120	R
						0		160
							bar

AXLE ROD

WASHER

METAL

BRACKET

SEMI-PNEUMATIC TIRE Fig. 6

11