ASSEMBLY
DANGER:
Never attach a wood cutting or carving blade of any type to this angle grinder. It is only designed for grinding. Use for any other purpose is not recommended and creates a hazard, which will result in serious injury.
DANGER:
Never attach a TYPE 1 straight or
Attaching the Side Handle
See Figure 3.
Unplug the grinder.
Screw the handle into the side of the gear housing.
Note: You can install the handle on either the left or right side of the grinder, depending on operator preference. It must always be used to prevent loss of control and possible serious injury.
Tighten the side handle securely.
POSITIONING THE GUARD
See Figures 4 - 6.
The guard on the grinder should be correctly installed de- pending on which side the handle is mounted. Never use the grinder without the guard correctly in place or when the index arrows are aligned.
WARNING:
Never place the guard so that it is in front of the grinder. This could result in serious injury because sparks and loose particles thrown from the grinding wheel would be directed toward the operator. Always place the guard in the correct location as shown.
To adjust the guard:
Unplug the grinder.
Depress lever and rotate the guard to its correct position as shown.
NOTE: Be sure the raised ridge on the guard is seated in the groove on the bearing cap. Never use the grinder without the guard in place and properly adjusted.
TOOLLESS
GUARD
| depress |
| lever |
| to ROTATE |
assembly of guard to grinder | Fig. 4 |
TOOLLESS
GUARD
SIDE HANDLE ON LEFT SIDE GRINDER | Fig. 5 |
|
|
TOOLLESS
GUARD
SIDE HANDLE ON RIGHT SIDE GRINDER | Fig. 6 |
|
|
11
