OPERATION
ADJUSTING THE AUXILIARY HANDLE ASSEMBLY
See Figure 2.
Unplug the drill.
Loosen the auxiliary handle assembly by turning the handle counterclockwise.
Rotate the auxiliary handle assembly to the desired location.
Tighten the auxiliary handle assembly securely by turning the handle clockwise.
SWITCH
See Figure 3.
To turn the drill ON, depress the switch trigger. Release the switch trigger to turn the drill OFF.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE) See Figure 4.
The direction of bit rotation is reversible and is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch trigger for drilling. The drilling direction is reversed when the selector is to the right of the switch trigger.
CAUTION:
To prevent gear damage, always allow the chuck to come to a complete stop before changing the direction of rotation.
To stop the drill, release the switch trigger and allow the chuck to come to a complete stop.
NOTE: The drill will not run unless the direction of rotation selector is pushed fully to the left or right.
Avoid running the drill at low speeds for extended periods of time. Running at low speeds under constant usage may cause the drill to become overheated. If this occurs, cool the drill by running it without a load and at full speed.
TO TIGHTEN
TO LOOSEN
AUXILIARY HANDLE
ASSEMBLY
Fig. 2
SWITCH TRIGGER
Fig. 3
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE)
Fig. 4
10
