MAINTENANCE
WARNING:
When servicing use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.
Insert hex key wrench in the chuck and tighten chuck jaws securely.
Tap sharply with a mallet in a counterclockwise direc- tion. This will loosen chuck on the spindle. It can now be unscrewed by hand.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommend using this tool for extended work on these types of materi- als. However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.
CHUCK REMOVAL
See Figures 9 - 10.
The chuck may be removed and replaced with a new one.
Unplug the drill.
Insert a 5/16 in. or larger hex key into the chuck of the drill and tighten the chuck jaws securely.
Tap the hex key wrench sharply with a mallet in a clock- wise direction. This will loosen the screw in the chuck for easy removal.
Open chuck jaws and remove hex key. Using a screw- driver, remove the chuck screw by turning it in a clockwise direction.
NOTE: The screw has
MALLET
CHUCK
JAWS
HEX
KEY
Fig. 9
SCREWDRIVER
Fig. 10
13
