OPERATION
INSTALLING BITS
See Figure 4.
nLock the switch trigger on the driver by placing the direc- tion of rotation
nRemove the battery pack from the driver.
nPull the coupler away from the driver (1).
nInsert driver bit to be used into the coupler (2).
nRelease the coupler (3).
nPull on the bit to make sure it is secured in the coupler. There may be some play in the installed bit, this is nor- mal.
NOTE: Use only impact quality bits with a locking groove.
WARNING:
Make sure the bit is secured in the coupler before using the driver. Failure to do so could cause serious personal injury.
REMOVING BITS
See Figure 4.
nPlace the direction of rotation selector in the center lock position.
nRemove the battery pack from the driver.
nPull the coupler away from the driver.
nRemove driver bit from the coupler.
CAUTION:
The impact driver is not designed to be used as a drill.
RELEASE COUPLER
TO INSTALL BATTERY PACK
See Figure 5.
nPlace the battery pack in the driver aligning raised rib on battery pack with groove in the driver's battery port.
nMake sure the latches on each side of the battery pack snap into place and the battery pack is secured to the driver before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installation of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 6.
nLocate the latches on the side of the battery pack and depress both sides to release the battery pack from the driver.
nRemove the battery pack from the driver.
RAISED RIBS
LATCHES
Fig. 5
PULL COUPLER 1 FORWARD
3
BIT
INSERT BIT 
2 
LOCKING GROOVE | COUPLER |
|
Fig. 4
DEPRESS LATCHES TO |
|
RELEASE BATTERY PACK | Fig. 6 |
|
12
