OPERATION
REVERSIBLE
See Figure 4.
TWO SPEED
GEAR TRAIN (HI-LO)
This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow chuck to come to a complete stop before changing the direction of rotation or the two speed gear train
To stop, release switch trigger and allow the chuck to come to a complete stop.
TWO-SPEED GEAR TRAIN
HI 2 SPEED
AUXILIARY
1
LO
SPEED
Fig. 7
See Figure 7.
Your drill has a
AUXILIARY HANDLE
See Figure 8.
An auxiliary handle is packed with the drill for ease of op- eration and to help prevent loss of control.
To use the auxiliary handle:
nOpen the clamping ring by turning the handle counter- clockwise.
nSlide the ring of the auxiliary handle onto the spindle col- lar of the machine behind the torque adjustment ring.
nTighten the auxiliary handle at the desired angle by turn- ing the handle clockwise.
Note: For convenience the screw has been trapped inside the auxiliary handle.
To prevent thread damage and possible loss of control, the auxiliary handle should be checked periodically for tightness. Do not operate the drill with the handle loose.
HANDLE ASSEMBLY
TO
TOLOOSEN
TIGHTEN
Fig. 8
13