OPERATION
REVERSIBLE
See Figure 4.
TWO SPEED
GEAR TRAIN (HI-LO)
This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.
HI 
SPEED
LO
SPEED
1
2
CAUTION:
To prevent gear damage, always allow chuck to come to a complete stop before changing the direc- tion of rotation or the two speed gear train
To stop, release switch trigger and allow the chuck to come to a complete stop.
TWO-SPEED GEAR TRAIN
See Figure 7.
Your drill has a
AUXILIARY HANDLE
See Figure 8.
An auxiliary handle is packed with the drill for ease of opera- tion and to help prevent loss of control.
To use the auxiliary handle:
■Open the clamping ring by turning the handle counter- clockwise.
■Slide the ring of the auxiliary handle onto the spindle collar of the machine.
■Tighten the auxiliary handle at the desired angle by turning the handle clockwise.
Note: For convenience the screw has been trapped inside the auxiliary handle.
To prevent thread damage and possible loss of control, the auxiliary handle should be checked periodically for tightness. Do not operate the drill with the handle loose.
22
20
18 
16 
Fig. 7
2 2
20
18
16 
Fig. 8
13
