RIDGID R84040 manual Applying Caulk

OPERATION
APPLYING CAULK
See Figure 11.	CAULK BEAD
n �Prepare the surface by removing any dust, dirt, or remnants
of old caulk. Make sure the area is clean and dry.
n Adjust caulk gun speed to application needs.
n Hold the gun at a slight angle. If filling a crack, insert the
spout into the crack, if possible; otherwise, run the caulk
gun along the surface.

n Squeeze the trigger on the caulk gun and move the caulk gun at an even pace along the surface.

NOTE: If the bead of caulk is too narrow, re-cut the nozzle to provide a larger opening. However, it is better to apply a thin bead of caulk and add a little more if necessary than to apply too much and attempt to remove the excess.

nTo end the caulk bead, release the switch trigger.

n For a finished appearance and to help the caulk adhere to application surfaces, draw a moistened finger or other “smoothing tool” along the caulk bead after applying.

n Use a damp towel or rag to clean off any excess caulk.

Fig. 11

15