OPERATION

TO INSTALL BATTERY PACK

„Lock the switch trigger on the drill by placing the direction of rotation (forward-reverse) selector in center position. See Figure 4.

„Place battery pack in the drill. Align raised rib on battery pack with the groove inside the drill. See Figure 5.

„Make sure the latches on each side of your battery pack snap in place and battery pack is secured in the drill before beginning operation.

CAUTION:

When placing battery pack in the tool, be sure raised rib on battery pack aligns with the slide on the bottom of the drill and latches snap into place properly. Improper assembly of the battery pack can cause damage to internal components.

TO REMOVE BATTERY PACK

„Lock the switch trigger on the drill by placing the direction of rotation selector in center position. See Figure 4.

„Locate latches on side of battery pack and depress to release battery pack from the drill. See Figure 5.

„The battery pack will automatically disconnect in direction to be removed when buttons are depressed.

„Remove the battery pack from your drill.

APPLICATIONS

You may use the two speed drill for the purposes listed below:

„Drilling in wood

„Drilling in ceramics, plastics, fiberglass, and laminates

„Drilling in both hard and soft metals

„Using driving accessories, such as driving screws with screwdriver bits

„Mixing paints

„Hammer drilling in concrete and masonry.

SWITCH

See Figure 6.

To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

VARIABLE SPEED

See Figure 6.

This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

FORWARD/REVERSE/LOCK OFF

SELECTOR

Fig. 4

DEPRESS LATCHES TO

RELEASE BATTERY PACK

Fig. 5

VARIABLE SPEED

SWITCHTRIGGER

Fig. 6

12

Page 12
Image 12
RIDGID R841151 manual To Install Battery Pack, To Remove Battery Pack, Applications, Variable Speed