![](/images/new-backgrounds/1302203/30220323x1.webp)
OPERATION
WARNING:
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Cutting all types of wood products (lumber, plywood, paneling)
Cross cutting/Rip cutting
Bevel cutting
Pocket cutting
NOTE: The use of abrasive
CAUTION:
If at any point during the charging process none of the LEDs are lit, remove the battery pack from the charger to avoid damaging the product. DO NOT insert another battery. Return the charger and battery to your nearest service center for service or replacement.
CAUTION:
Charge in a well ventilated area. Do not block charger vents. Keep them clear to allow proper ventilation.
NOTE: Charge only RIDGID
Refer to the General Safety Rules for compatibility.
THE FOLLOWING INSTRUCTIONS ARE FOR RIDGID 24V
CHARGING THE BATTERY PACK
NOTE: New 24 Volt
It is not necessary to drain the battery pack completely before recharging.
CHARGE
LEVEL INDICATOR
24v | Li |
| ? |
Fig. 4
12