Model
OFF. Any tool that cannot be controlled with the switch is dangerous and must be repaired.
•Store idle tools out of the reach of children and other untrained persons. Tools are dangerous in the hands of untrained users.
•Maintain tools with care. Properly maintained tools are less likely to cause injury.
•Check for breakage of parts and any other condi- tion that may affect the tool’s operation. If dam- aged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
•Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.
•Inspect tool and extension cords periodically and replace if damaged. Damaged cords increase the risk of electrical shock.
•Keep handles dry and clean; free from oil and grease. Allows for better control of the tool.
•Check electrodes for wear and replace before the threaded studs show. Prevents electrical arcing and excessive current draw.
Service
•Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified repair personnel could result in injury.
•When servicing a tool, use only identical replace- ment parts. Follow instructions in the Maintenance Section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of electrical shock or injury.
•Disconnect all power from the unit before servic- ing. Eliminates the risk of electrical shock and acci- dental starting.
Specific Safety Information
WARNING
Read this operator’s manual carefully before using the Electric Soldering Gun. Failure to understand and follow the contents of this manual may result in electrical shock, fire and/or serious personal injury.
Call the Ridge Tool Company, Technical Service De- partment at (800)
Tool Safety
•Tool is made to solder copper pipe. Follow instruc- tions on proper use. Other uses may increase the risk of injury.
•Do not leave the unit unattended. Such preventive measures reduce the risk of injury or fire.
•Do not touch solder gun sleeves or carbon tips. They remain hot after use.
•Do not operate unit with the electrical box cover removed. Exposure to internal parts increases the risk of electrical shock.
•Use soldering sleeves and carbon tips provided with unit. Incorrect carbon tips or sleeves may result in overheating of the wires.
•Keep soldering sleeves away from combustible materials or articles that can be damaged by heat. Soldering sleeves and carbon tips remain hot after use.
•Do not solder near combustible materials. Copper pipe and soldering sleeves reach temperatures that can result in fire.
•Do not store the handle in the case until the carbon tips have cooled. They may burn the cord or solder gun cable.
•Do not clamp or touch threaded studs or stainless steel sleeves against pipe or fittings. Prevents elec- trical arcing and excessive current draw that may kick out circuit breaker.
Description, Specifications and Standard Equipment
Description
The
Specifications
Power Input | 115 V, 15 A | |
Power Output | (open circuit voltage) | |
| Hi = 7.0 V, Low = 6.2 V | |
Current Draw | 13.5A | @ Low Setting |
| 15.0A | @ High Setting |
Ridge Tool Company | 3 |
