![Safety Symbols](/images/new-backgrounds/38317/383173x1.webp)
Safety Symbols
This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. It may also be used to alert against unsafe practices.
Technical Data
Weight 37 lbs (16.8kg) | Dimensions | Width | 16 | 3/4 in (425mm) |
|
| Height | 26 | 5/8 in (676.5mm) |
|
| Depth | 9 13/16 in (250mm) |
| Natural Gas | Propane Gas | |
Minimum supply gas pressure | 3.5 in (89mm) W.C. | 8.0in (203mm) W.C. | |
|
|
| |
Maximum supply gas pressure | 10.5 in (267mm) W.C. | 13.0 in (330mm) W.C. | |
|
|
| |
Manifold test pressure (Low) | 0.6 in (16mm) W.C. | 1.1 in (27mm) W.C. | |
|
|
| |
Manifold test pressure (High) | 2.3 in (58mm) W.C. | 3.7 in (94mm) W.C. | |
|
|
| |
High Altitude - Manifold test pressure (Low) | 0.6 in (16 mm) W.C | 1.1 in (27 mm) W.C. | |
|
|
| |
High Altitude - Manifold test pressure (High) | 1.7 in (42 mm) W.C. | 2.7 in (68 mm) W.C. | |
|
|
| |
BTU/hour input | Low 5500 - High 11000 | Low 5700 - High 11000 | |
|
|
| |
BTU/hour output | Low 4450 - High 8800 | Low 4600 - High 8800 | |
|
|
| |
Injector | |||
0.051 in (1.30mm) | 0.035 in (0.90mm) | ||
| |||
|
|
| |
Primary damper | |||
|
|
| |
Secondary damper | |||
|
|
|
The input rate can be verified by following the procedure in the National Fuel Gas Code (NFPA54 / ANSI Z223.1, 2006 or latest edition).
High Altitude Installation
Conversion of the appliance for operation at high altitudes (> 2000 ft, 610 m) requires the completion of the section, Adjust Gas Pressure Settings, using the high altitude manifold test pressures above. No parts need to be replaced for high altitude.
For high altitude installations in Canada, the conversion shall be carried out by a manufacturer’s authorized representative, in accordance with the requirements of the manufacturer, provincial or territorial authorities having jurisdiction and in accordance with the requirements of
Rinnai Corporation |