ritetemp 401-014 Rear View of control unit, 12/24hr, jumper, Circuit, Board, Check Unit cont

6 Check Unit cont.

Note: If you have an electric furnace system and the blower does not operate after installation, remove the thermostat, turn it over, and find the electric/gas heat selector jumper on the back of the control unit. Switch it to "Elect"(see Diag below).

Congratulations, you have successfully installed your unit. Please proceed to the OPERATING Guide to initialize the new thermostat.

7 Power Options
1) The 8022C can run on batteries only. (2AA Alkaline)					24VAC and MV
The batteries will last well over 1 year. If the batteries are not replaced the
thermostat will stop working.
2) The 8022C can run on the C wire if available.						24VAC ONLY
As shown in the wiring diagrams, The C wire is the other side of the 24VAC
heating transformer. If the C wire is used, the batteries are then for AC power
loss only and will last much longer. The thermostat will continue working if the
batteries die.
PG 9
		Rear View of control unit
							12/24hr
							jumper
			12
			24
				oF
				oC			oC -oF
							jumper
	ELECT GAS						Circuit
							Board

Gas - Electric jumper

PG 10