Rival 8804 Know Your Ice Cream Maker, Motor Drive, Rubber Cork, Cover, Dasher, Ice Cream Can

8804/8806/9100200000501 V.qxd 12/19/05 10:19 Page 5

KNOW YOUR ICE CREAM MAKER

•	MOTOR DRIVE	MOTOR DRIVE
	Top mounted. Engages stem of
	DASHER and locks to bucket.	RUBBER CORK
•	RUBBER CORK	COVER
	Used to plug hole in COVER
	when hardening ice cream.
•	COVER	DASHER
	Tab in COVER fits notch in ice	ICE CREAM CAN
	cream can.
•	DASHER	BUCKET SLOTS
	Stem on top fits through hole in
	center of COVER, and engages	DRAIN HOLE
	MOTOR DRIVE.	BUCKET

•ICE CREAM CAN

Container holds ice cream mixture.

•DRAIN HOLE

Allows salt water to flow freely out of BUCKET.

•BUCKET

MOTOR DRIVE tabs secure BUCKET. DRAIN HOLE located near top of BUCKET. Holds rock salt and ice.

HOW TO USE YOUR ICE CREAM MAKER

NOTE: Before using for the first time, wash all parts except MOTOR DRIVE (see “HOW TO CLEAN YOUR ICE CREAM MAKER”).

1.Pour chilled ice cream mixture into cooled ICE CREAM CAN. Fill ICE CREAM CAN only 3/4 full, as mixture will expand during freezing.

2.Insert DASHER. Be sure that bottom of DASHER fits the indentation at bottom of ICE CREAM CAN.

3.Place COVER on ICE CREAM CAN.

	MAKER SIZE
For best results use Rival® Rock Salt	4 Quart	6 Quart
ROCK SALT for making ice cream	3 Cups	4 Cups
ROCK SALT for hardening ice cream	2 Cups	3 Cups
CRUSHED ICE for making and hardening ice cream	5-10 lbs.	10-15 lbs.

4.Place filled ICE CREAM CAN in BUCKET. Make sure ICE CREAM CAN is centered and engages with bottom of BUCKET.

5.Place MOTOR DRIVE over ICE CREAM CAN so that stem of DASHER engages hole in bottom of MOTOR DRIVE. Rotate ICE CREAM CAN slightly until MOTOR DRIVE engages ICE CREAM CAN COVER. Fit the four tabs on the bottom of MOTOR DRIVE into holes at the top edge of the bucket. Rotate the MOTOR DRIVE counter clockwise to secure to bucket. Plug power cord into 120 volt AC outlet.

6.While ice cream maker is running, distribute 2 inches of ice around bottom of BUCKET. Sprinkle approximately 1/4 cup salt uniformly over layer of ice. (See “Important points”) NOTE: The DASHER does not move, the ICE CREAM CAN turns around it.

7.Continue adding layers of ice, with salt between layers, until ice level reaches top of rotating ICE CREAM CAN. NOTE: Should ice cream maker stop before churning is complete (approximately 20-40 minutes), check to see if large ice cubes are jammed against the rotating ice cream can. (See “Important Points”)

8.Ice cream should churn about 20-40 minutes or until motor stops. Unplug and remove MOTOR DRIVE.

9.Clear ice and salt away from top of ICE CREAM CAN. Wipe carefully to remove salt and water before removing the COVER. Lift out DASHER and scrape clean with a rubber spatula. Pack ice cream down into ICE CREAM CAN.

-4- -5-