Establishing communication
Rocketboost products form an audio network and each Rocketboost wireless receiver can select the audio from any Rocketboost wireless sender in the network.
Important
Every Rocketboost network must contain one hub device, which helps devices join the network. The network can have only one hub, which you can enable using the hub switch on the back of all Rocketboost wireless senders and wireless sender/receivers.
The
Important: Hub devices must always have power for your network to operate. The hub device can be in standby (power saving) mode, but must stay plugged in.
To establish communications:
1If possible, bring your Rocketboost hub device and the new Rocketboost wireless receiver into the same room.
2Press the Power button on the Rocketboost hub device to turn it on.
3Press the Power button on your Rocketboost wireless receiver to turn it on.
4Press and hold the 
on the Rocketboost hub device for more than three seconds to put it into pairing mode. The power indicator starts blinking rapidly and the unit will stay in pairing mode for 30 seconds.
5Press and hold the 
on your Rocketboost wireless receiver for more than three seconds to put it into pairing mode.
•When successfully paired, the power indicator LEDs on both products will stop blinking and stay on.
•If pairing fails after 30 seconds, the power indicator LEDs will begin flashing at a slower rate. If this occurs, repeat the above steps.
Power on indicator