WirelessHD® Adapter
| QUICK SETUP GUIDE |
Important safety information
This guide contains important safety instructions. Read and follow all instructions carefully while installing and using the adapter. Read this guide thoroughly before trying to unpack, install, or use your adapter. Save these instructions in a readily accessible place.
•Caution: Always treat your adapter with care and keep it in a clean and
•Do not expose your adapter to liquid or moisture or humidity.
•Do not expose your adapter to temperatures above 104°F (40°C) when unit is operated.
•Do not drop or throw your adapter.
•Do not attempt to disassemble or modify your adapter. Only authorized personnel should perform service.
•Your adapter is not
•Do not use a different AC adapter to avoid unit burn or smoke.
Package contents
• 60 GHz WirelessHD transmitter | • | Power adapters (2) | |
• | 60 GHz WirelessHD receiver | • Base mounting brackets (2) | |
• | HDMI cables (2) | • | Quick Setup Guide |
Transmitter and receiver front panels
1 Link LED (blue)
2Weak LED (green)
3Strong LED (green)
Warning: If all four LEDs are blinking at the same time, the internal cooling fan is not working. Turn off the adapter and contact Rocketfish customer service.
4Power indicator
Side panel
RESET CFG
5RESET AND CFG
These buttons are for service at the factory only, please do not press them.
Transmitter and receiver back panels
6DC-IN
Connect the power adapter to this jack and to a power outlet.
7Power switch
Press the Power switch to turn the unit on.
8HDMI
Used to connect the HDMI cables from the source component to the transmitter, and from the receiver to the TV/Projector.
Setting up
To attach the base stands:
1Align the holes on the base stand with the mounting tabs on the bottom of the transmitter or receiver.
2Press the stand down, then slide it to the left so the tabs hold the stand in place.
To connect the transmitter and receiver:
1Connect one HDMI cable from the output of the source component
send HD signals wirelessly from up to four source components.
Note: For connection to a computer with a DVI output, use Rocketfish model
2Connect the other HDMI cable from the output on the back of the receiver unit to
an available HDMI input on the HDTV or HD Projector.
3Connect the power cords to the DC IN jacks on the transmitter and receiver and to a power outlet.
4Turn on the connected devices, then press the power switches on the transmitter and receiver to the ON position.
Positioning the transmitter and receiver
For best results, the transmitter and receiver should:
•Face each other within the same room
•Be no more than 33 feet (10 meters) apart
•Be on the same level (one should not be higher than the other)
•In open spaces (not in a cabinet or an enclosed shelf)
Note: If you begin to see your video breaking up, try repositioning the device providing the transmitter as many open paths to the receiver as possible.