Rockford Fosgate 5X, 3X, 2X owner manual INPUT/OUTPUT Levels & Connections

M O U N T I N G A N D W I R I N G T H E E L E C T R O N I C C R O S S O V E R S

The information below describes the various considerations for mounting and connecting the active crossovers. For additional infor- mation see the wiring diagrams beginning on page 10.

We recommend mounting the crossover as close to the amplifier(s) as possible.

The B+ (Power) supplies power to the unit. Connect this terminal to a constant +12 Volt power source by way of an in-line fuse.

The GND (Power Ground) grounds the unit. Connect this terminal to the chassis of the vehicle. When grounding the unit be sure to scrape all paint from the metal to ensure a clean electrical connection.

The REM (Remote Turn-On) turns on the unit by way of a +12 Volt supply source. Connect this terminal to the source unit’s “Amplifier” or “Auto Antenna” lead, either of which will go to +12 volts whenever the source unit is on.

If your source unit does not have either a Remote or an Auto Antenna lead (or if the Auto Antenna goes down during tape operation), we recommend installing a switch to control the unit manually.

INPUT/OUTPUT LEVELS & CONNECTIONS

The Punch Electronic Crossovers are designed for preamp (input up to 2VRMS) levels. Net gain in the crossover is unity. (Output levels are equal to input levels.)

When connecting the input and output terminals be sure to use high quality shielded interconnecting RCA cables.

•Connect source unit's OUTPUT jacks to the desired crossover INPUT jacks.

•Connect the desired crossover’s OUTPUT jacks to the Amplifier’s INPUT jacks.

– 6 –