Roksan Audio FR - 5 S E T U P, Important Note, Conventional, Connecting Loudspeaker Cables

S E T U P C a s p i a n FR-5Loudspeaker

NOTE:

To assist setup, do not fit the speaker spikes yet. This will be done after the optimum position/location of the speakers in the room is established.

CONNECTING LOUDSPEAKER CABLES Conventional

Please refer to rear terminal panel view on Page 4. There are two sets of terminals the upper set corresponds to the tweeter and the lower to the woofers. There is a small illustration printed on the rear label for your reference. The Caspian FR-5Loudspeaker comes supplied with a set of two removable ‘jump-bars’ already connected. To connect the loudspeaker conventionally, simply attach your speaker cable to the lower set of terminals marked ‘woofer’. Make sure that both loudspeakers of the pair are connected in the correct polarity with respect to the output terminals of your amplifier:

	RIGHT	Ä RIGHT		and	LEFT	Ä LEFT
and	RED	Ä	RED	and	BLACK	Ä	BLACK
or	+ve	Ä	+ve	and	-ve	Ä	-ve

IMPORTANT NOTE:

Always switch the Amplifiers OFF before attempting to connect or disconnect the speaker cables to/from your loudspeakers. Failure to do this may cause permanent damage to the amplifier and/or the loudspeakers.

	Conventional
	NOTE:
AMPLIFIER	‘Jump-
	bars’
	Connected
NOTE:

For optimum performance it is recommended to use high quality cables such as ROKSAN HDC- 02S High Definition Speaker Cable. Many speaker cables such as the ROKSAN HDC-02S are directional. Please observe this directionality. DO NOT use speaker cable with conductor size less than 16 AWG (1.6mm Diameter). The Binding posts accept conductor sizes up to 12 AWG.

Roksan Audio ltd	Caspian FR-5 Loudspeaker User Manual
CLASSIFICATION: General Use	Version: 1.07

All specifications are liable to change without notice. E&OE Page 6 of 12 ENGLISH