KNOW YOUR CASPIAN
•When you first power up from the Mains Switch on the rear panel, the amplifier runs a
•During Standby, the power stage of the amplifier shuts down to reduce power consumption and heat.
•If the amplifier overheats through overload or lack of ventilation, the Caspian will revert to Standby until it has cooled down. If it subsequently overheats the amplifier will revert to Standby and stays in Standby. You will then have to wait until the amplifier cools down fully and will have to bring it out of Standby manually.
In the unlikely event of an internal fault such as a power supply failure, the MODE Indicator light will flash GREEN and the amplifier will shut down. The amplifier will then run a
| T R O U B L E S H O O T I N G | C a s p i a n Integrated Amplifier |
|
|
| ||
|
|
|
|
If you suspect that your ROKSAN Caspian Integrated Amplifier is not operating properly, you should check all the connections carefully. Pay particular attention to speaker phasing and channel connections. Phono plugs should be fully inserted- a frequent cause of problems is that Phono plug surrounds do not make proper contact. Below are some commonly encountered problems with suggestions for possible cure. The list is not exhaustive: If you have any unresolved problems, please consult your appointed ROKSAN dealer or distributor.
SYMPTOM | LIKELY CAUSE | SUGGESTED REMEDY |
No power | AC Mains lead not inserted properly | Ensure AC Mains lead is fully inserted |
| Unit not switched on at rear panel | Switch unit on at rear panel |
No output on one or both | Amplifier in | Press MODE button to set amplifier in |
channels | GREEN) | operational mode (MODE light RED) |
| Missing or bad input signal connection | Check all input connections |
| Incorrect speaker connection | Check speaker output connections on |
|
| rear panel |
| Wrong input selected | Select correct input, ascertain source is |
|
| working |
| Tape Monitor selected | Deselect Tape Monitor |
| Over heating | Allow amplifier to cool, increase |
Very low sound output |
| ventillation or use at lower volume |
| Amplifier set in MUTE position | Deselect MUTE (check volume setting |
Poor speaker imaging, lack |
| first) |
of Bass output | Loudspeakers connected out of phase | Check polarity of speaker connections |
|
| (especially important if |
|
| |
|
|
|
Hum from speakers | Incorrect Grounding | Check Mains polarity and grounding on |
|
| all connected equipment |
Roksan Audio ltd |
| Caspian Integrated Amplifier User Manual |
CLASSIFICATION: General Use | Page 9 | Version 3.07 |
All specifications are liable to change without notice. E&OE | ENGLISH |