11
Playback Instructions (Control Input Playback)
Selecting the Control Input Mode
With the power to the AR-200S switched off, set the MODE switches on the
bottom panel as shown below.
SW 1:
OFF,
SW 2:
OFF
Assigning Phrases to the Terminals
Assign phrases 1 through 9 to Port Nos. 1 through 9.
Settings in Effect When a Card Is Formatted
By inputting control signals directly to Port Nos. 1 through 9, you can play
back the phrases assigned to those numbers. Up to 9 phrases can be played
back. Assign phrases 1 through 9 beforehand to Port Nos. 1 through 9.
This is very convenient when you want to specify a desired phrase directly
using a switch, relay, sensor, or other such means.
fig.CtrIn-Dir01.e
fig.CtrIn-DirPin.e
* Control Input and DC Input Terminal (CONTROL A) “1, 2” are connected in
parallel with Control I/O Connector (CONTROL B) “1, 2.”
fig.CtrIn-Dir02.e
Playback:
Input a control signal to a Port, 1–9.
→
The phrase assigned to the Port is played back.
Stopping:
Input a control signal to Port 10 (STOP).
→
Playback of the phrase is stopped.
Priority Order
The most recently input control signal is given priority in playback.
•
If a new and different control signal is input during playback of a
phrase
Playback of the current phrase is stopped, and playback of the specified
phrase then begins.
fig.CtrIn-Dir03B.e
•
While the control signal is continuously input
Playback is repeated while the signal is input.
fig.CtrIn-Dir04.e
Selecting the Control Input Mode
With the power to the AR-200S switched off, set the MODE switches on the
bottom panel as shown below.
SW 1:
ON,
SW 2:
OFF
Assigning Phrases to the Terminals
Assign phrases 1 through 9 to Port Nos. 1 through 9.
Settings in Effect When a Card Is Formatted
AR-200S Settings
Port No. 1 2 3 4 5 ••• 9
Phrase 001 002 003 004 005 ••• 009
Playing Back Phrases Assigned to the Connectors (Direct Playback)
Connectors Used for Direct Play (Last-In)
(Control I/O Connector)
1–9
Inputting a control signal directly to the terminal with the
number corresponding to the phrase starts playback of the
phrase.
10 (STOP)
This stops phrase playback.
11/12 (COM)
Shorting with the above terminals results in “ON.”
Port No.
Phrase
• • •
• • •
1
001
2
002
3
003 004
4
005
59
009
A Control
Signal
10 1 1 2
Select a Phrase COM
9
STOP
1211
COM
Operational Specifications for Direct
Playback (Last-In)
AR-200S Settings
Port No. 1 2 3 4 5 ••• 9
Phrase 001 002 003 004 005 ••• 009
002
Audio Output
Port No. 1
Port No. 2
STOP Port
001
001 Interrupted
001 002
001 Interrupted
Audio Output
Port No. 1
Port No. 2
Audio Output
Port No. 1
001 001 001
AR-200S_e.book 11ページ ２００５年１２月８日 木曜日 午前９時３分