6

Installation

Attach these as required, such as when you’re using the AR-200S without
mounting it on a rack or the like.
Peel off the double-sided tape from the rubber feet and affix the rubber feet at
the locations shown in the following figure.

fig.Set-01

When you are mounting the unit on a rack or the like, give attention to the
following points to ensure efficient cooling.
• Install in a well-ventilated location.
• Avoid mounting in a sealed rack. Warm air within the rack cannot escape
and is sucked into the unit again, making efficient cooling impossible.
• When you are using a stacked mounting arrangement, be especially sure
to provide for adequate ventilation within the rack to keep discharged air
from being sucked back into the unit. If the back surface of the rack
cannot be kept open, then provide a ventilation port or ventilation fan at
the upper area of the back surface of the rack, where warm air
accumulates.
• When you are using the unit in a portable case or rack, remove the covers
from the front and back surfaces of the case, so that the front and back
surfaces of the unit are not obstructed.
* When placing the unit on the rack, be careful not to pinch your fingers.
* For more information about installation, also see
“Placement”
in the
Important Notes (p. 3).
By attaching a rack mount adaptor (RAD-50: sold separately) to the AR-200S,
you can install it in an EIA rack. One RAD-50 can accommodate up to two AR-
200S units.
1.
Remove the four rubber feet from bottom of the unit.

fig.Set-02.e

2.

Attach the RAD-50 adaptor to the AR-200S using the screws that are
supplied with the RAD-50.

fig.Set-03

By attaching the Card Protector (supplied) to the AR-200S, you can prevent the
memory card from inadvertently being removed from the AR-200S.

1.

After confirming that the card is securely inserted in the card slot,
use the provided screws to attach the Card Protector, as shown in
the figure below.

fig.CardProtect.e

Attaching the Rubber Feet (Included

Items)

Rack Mounting (Important Notes on

Heat Radiation)

Rack-Mounting the AR-200S

Attaching the Card Protector

Note: Do not use these holes.
RAD-50
Card Protector
AR-200S_e.book 6ページ ２００５年１２月８日　木曜日　午前９時３分