Roland BR-800 Turning the Power On/Off

Turning the Power On/Off

Once the connections have been completed (p. 32), turn on

power to your various devices in the order specified. By

turning on devices in the wrong order, you risk causing

malfunction and/or damage to speakers and other devices.

Check the following before you turn on the power.

❒

Have connections with your external equipment

been made correctly?

❒

Are the volume controls of the BR-800 and the

connected equipment set to the minimum position?

❒

Is the SD card inserted? (p. 142)

Lower the BR-800’s [MASTER] fader.

fig.P-On01.eps

Switch on the power to the equipment connected to

the input jacks (GUITAR/BASS, INPUT, LINE IN).

Turn on the [POWER] switch located on the side

panel.

fig.P-On02.eps

Switch on the power to the equipment connected to

LINE OUT jacks.

Make sure that song playback is stopped.

Turn off your equipment in the reverse order of when

you turned them on.

Make sure that the BR-800’s display does not indicate

“Keep power on!”

Turn the BR-800’s [POWER] switch off.

Turning the Power On

Turning the Power Off

• Make sure that the recorder is stopped before you

switch off the BR-800’s power. If you turn off the

power during recording or playback, the data,

mixer settings, or effect patch data will be lost.

• When using the AC adaptor, take care that the AC

adaptor is not unplugged during use. Data may be

lost if the AC adaptor is unplugged during

operation.

• When powering the unit on power from a USB

bus, exercise due caution in preventing the USB

cable from being disconnected during use of the

unit. You risk damaging your data should the

USB cable get disconnected.

• Turning the power off while the display indicates

“Keep power on!” will result in loss of data. Never

turn off the power while this indication is shown.

• This unit is equipped with a protection circuit. A

brief interval (a few seconds) after power up is

required before the unit will operate normally.

• When the BR-800 is shipped from the factory, an

SD card is inserted in the MEMORY CARD slot.

• Always make sure to have the volume level

turned down before switching on power. Even

with the volume all the way down, you may still

hear some sound when the power is switched on,

but this is normal, and does not indicate a

malfunction.

• Do not touch the buttons while turning on the

BR-800’s power.

The unit might malfunction if you turn on the

power while touching a button.

BR800_e.book 34 ページ２０１０年３月２日　火曜日　午後６時４０分