22
Advanced Edit
1.
Press [EDIT], and then the [ ], until you see
<KIT/MIDI>.
2.
Press the [ ] and you see the Kit Volume.
Note#
3.
Press the [ ] until you see:
* The MIDI Note # for each pad can be changed, and the
HandSonic will remember these on a “per kit” basis. You
would only need to do this when triggering an external
sound module. An “*” will appear to the right of the note
number if two pads use the same note number within the
same kit. Please be careful, because if identical MIDI
messages are received from an external sequencer or MIDI
controller, the HandSonic will not sound as you expect.
* If recording a performance on an external sequencer, and
using a Foot Switch for Hi-hat control, the HandSonic will
transmit a note number 4 steps lower than the one
assigned to the pad being played. (ONLY if this pad has a
sound capable of Hi-hat control.) This will occur only while
the foot switch is pressed and the pad is played.
Gate Time
ALT & GATE refer how “note on/note off” is handled. Only
certain sounds respond to these functions, the indications
appear above the instrument name in the display or you can
see this in the instrument list on page 34.
For an example, go to KIT #18 “Pot Drum”.
1.
Press [EDIT], then the [ ] and play the large pad on
the right.
You will see <NOTE OFF> appear above the instrument
name.
2.
Press and hold the pad for a few seconds, then
release your hand.
This is how GATE functions.
3.
Press the [ ] once and then [ ] until you see
<KIT/MIDI>.
Press the [ ] and then the [ ] until you see
<Gate Time>.
4.
Play the same pad, and change the Gate Time
parameter to “ALT.”
5.
Now tap the pad once, and then again.
You will hear how ALT works.
SCRAPE works only with the D Beam and literally allows
you to scrape a sound with your hand movement.
KIT Parameters
KIT Volume
MIDI
All Pads
GATE, ALT, 0.1–8 seconds.
D Beam
SCRAPE, GATE, ALT,
0.1–8 seconds.
External Trigger/
Foot Switch
ALT, 0.1–8 seconds.
HPD-10_e1.book 22ページ ２００６年４月７日 金曜日 午後２時１４分