15
5.
Mounted Position of the Object and the Scannable Area
The scannable area may differ slightly according to the scanning mode. The area that you can actually scan is affected by the mounted position of the
object. Also, mount the object so that it does not extend beyond the table.
Plane Scanning
Multi-plane Composition (Two to Six Scanning Surfaces)
For multi-plane composition, mount the object near the center of the table. If it is mounted at the edge of the table it will fall outside the
effective sensor area, making correct scanning impossible.
When There Is a Single Scanning Surface
When you are scanning only one surface, mount the object so that the surface you want to scan lies to the right of the center of the table.
Table
230 mm
(9 in.)
406.4 mm
(16 in.)
3 mm
(1/8 in.)
Table
230 mm
(9 in.)
406.4 mm
(16 in.)
3 mm
(1/8 in.)
Yes NoScannable area for
multi-plane composition
Scannable area when there is
a single scanning surface
4. Rotary Scanning 5. Mounted Position of the Object and the Scannable Area