Roland PK-25A Connecting to the VK-88

Connecting to the VK-88

Use the PK cable that is supplied with the VK-88 to connect the VK-88 and PK-25A.

The supplied AC adaptor is not used. The PK-25A will be turned on/off by the power switch of

the VK-88, regardless of the position of the PK-25A’s own power switch.

Make sure that the VK-88’s power is turned off.

Set the PEDAL KEYBOARD [SELECT] switch (located on the rear panel

of the VK-88) to the PK IN position.

Use the PK cable that is supplied with the VK-88 to connect the VK-

88’s PK IN connector to the PK-25A’s PK OUT connector.

Once the connections have been completed, turn on power to your various devices in the order specified. By

turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other

devices.

As explained on the VK-88 Owner’s Manual, turn on the power of the

VK-88.

Make sure that the indicator on the rear panel of the PK-25A is lit.

Play the pedal keyboard. If you hear the pedal part of the VK-88,

connections are complete.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required

before the unit will operate normally.

If connecting the PK-25A to a VK-88, set the OCT SHIFT (Octave Shift) switch to the “0” position.

MEMO

PK OUT Jack

PK IN Jack

The VK-88 includes a PK cable that is longer than

the PK cable supplied with the PK-25A. If you are

connecting the PK-25A to a VK-88, we recommend

using the PK cable that is supplied with the VK-88.

PK cable that is supplied

with the VK-88

NOTE

MEMO

PK-25A_e 9ページ２００５年１１月１７日　木曜日　午前１０時２０分