126
Chapter 8: Specifications
8-2 About the Printing or Cutting Area

The printing or cutting area along the horizontal plane (the direction in which the carriage moves) is determined by the

position of the pinch rollers. The workable area spans the length between the two rollers, minus a margin of about 1.5 mm

(about 0.06 in.) on both sides.

If "PIECE" has been selected and media length (the distance in the X direction as shown in the figure) is 2,000 mm (78-

3/4 in.), the area is the same as when "EDGE" has been chosen.

Max.:
1346 mm (53
in.
)
Pinch roller (right)
Printing or cutting area
Material
Max.: 24998 mm
(984-1/8 in.)
10 mm
(3/8 in.)
Approx. 1.5 mm
(about 0.06 in.)
90 mm
(about 3-9/16 in.)
P
inch roller (left)
75 mm (3 in.)
(If the material configuration is "EDGE" or "PIECE.")
10 mm
(3/8 in.)
Approx. 1.5 mm
(about 0.06 in.)
Printing or cutting
coordinates origin (0, 0)
75 mm (3 in.)
(If the material configuratio
n
is "EDGE" or "PIECE.")

* The arrows in the figure indicating the X and Y directions indicate

respectively the positive directions of the X axis and Y axis.

When crop marks are printed, the printing or cutting area in the area shown above is reduced by an amount equal to the

size of the crop marks (12.5 mm (0.5 in.) + 12.5 mm (0.5 in.)).

12.5 mm
(0.5 in.)
P
inch roller
(
left)
12.5 mm
(0.5 in.)
T
he area
s
hown above
Printing or cutting area when crop marks are printe
d
Crop mark
The area shown above
Crop marks
12.5 mm
(0.5 in.)
12.5 mm
(0.5 in.)
Crop mark
Default area
Pinch roller (right)
Printing or cutting
coordinates origin (0, 0
)