Roland SSW-351 owner manual Making Connections, SST-151/251/SSM-151

Making Connections

1.Before you make connections, make sure that the power of all equipment is turned off. Also make sure that the volume controls on your amplifier and mixer are turned to the minimum position.

2.Use speaker cables to connect the output terminals of the amplifier to the inputs of the speakers.

When connecting speakers, pay attention to the polarity (+/-) of the amplifier.

The SST/SSW/SSM speakers have a nominal impedance of 8 ohms. Check the recommended load impedance of your amplifier.

When connecting speakers in parallel, make sure that the polarity matches. Since the total impedance of all speakers will decrease if they are connected in parallel, check the recommended load impedance of your amplifier once again to make sure.

In order to get the best sound quality, please use thick and sturdy speaker cables. Avoid using cheap cables, or shielded cables intended for use with a guitar. In order to achieve high-reliability connections, we recommend that you use Speakon® connectors (speaker connectors). When making Speakon® connections, refer to the network circuit diagram in the specifications.

These speakers are equipped with self-recovering protection circuitry designed to guard the tweeters from excessively high input and abnormal signals. The circuit is tripped when the speaker is presented with excessive input, thus preventing sound output from the tweeter; this does not indicate a malfunction. In such instances, lower the amp volume; the tweeter function is restored automatically after 5– 10 seconds. Contact a Roland Service Center if the speaker function does not recover properly.

The Roland SST/SSW speakers are designed to allow multiple units to be combined to create high- output spaker clusters. The SSW-351 speaker system can be driven with a single amp when using its built-in crossover network, or driven with a multi-amp system when an external crossover is used, and is also the ideal subwoofer system for use in conjunction with a SST-151/251. In order to take full advantage of its performance and to protect the speakers, please read the following explanations carefully.

SST-151/251/SSM-151

Connect the inputs of the SST-151/251/SSM-151 directly to your amplifier. If you wish to add an additional SST- 151/251/SSM-151, connect it in parallel. To connect the additional SST-151/251/SSM-151, use the second PARALLEL INPUTS an an output.

Basic Connection	Parallel Connection
FULL RANGE PARALLEL INPUTS	FULL RANGE PARALLEL INPUTS	FULL RANGE PARALLEL INPUTS

DESIGNED BY ROLAND AUDIO DEVELOPMENT CORP.

IN CALIFORNIA, USA

Select any one of the input jacks.

from the amplifier

(input impedance: 8 ohms)

DESIGNED BY ROLAND	AUDIO DEVELOPMENT	CORP.	DESIGNED BY ROLAND	AUDIO DEVELOPMENT CORP.
IN CALIFORNIA, USA			IN CALIFORNIA, USA

from the amplifier

(combined input impedance: 4 ohms)

4