11
Panel Descriptions
fig. front.eps
4. Compressor/Limiter threshold knob
This adjusts the threshold of the compressor/limiter.
Turning the knob toward the right will lower the level at which the compressor/limiter begins to be
applied. If the rear panel compressor/limiter type switch (22) is set to compressor 1 (or 2), the
gain (makeup gain) will rise as the threshold level is lowered, producing a fat sound.
Turning this all the way to the left will turn off the compressor/limiter.
* Turning this knob toward the right will strengthen the compressor effect, which may create the
impression that the tone is being affected. If this occurs, turn the threshold knob back toward
the left until the tonal change is not noticeable.
* If you want to turn the circuit itself completely off, set the rear panel compressor/limiter type
switch (22) to the OFF (BYPASS) position.
5. Peak indicator
This indicates the input signal level. Use the input sensitivity knob (2) for each input jack to adjust
the input level so that the peak indicator does not light.
If the rear panel compressor/limiter type switch (22) is set to OFF (BYPASS) position, the peak
indicator will light red. The compressor/limiter type switch is set to compressor 1, 2 or Limiter
position, the peak indicator will light green.
6. Digital input switch
If you want to record from the digital input, turn this ON (pressed inward ).
This allows you to synchronize with the external digital device connected to the digital input
connector (17).
*In digital input mode you will not hear the sound from the computer. The settings of the direct
monitor section will be ignored. This means that the direct monitor switch (9), STEREO/MONO
select switch (8), and direct monitor volume (10) will not do anything.
Digital input switch Status
ON with a digital device connected to
the digital input connector
The input from the digital input connector (17) is sent to the
computer (Digital input mode).
OFF The input from the combo input jacks (1) is sent to the computer.
ON with no digital device connected
to the digital input connector
The audio signal (sound) that is output from the computer via USB
will pass through the UA-25EX and return to the computer
(LoopBack mode).
16728 910 115121343
UA-25EXCW_e.book 11 ページ 2009年4月13日 月曜日 午後12時33分