157
Vocal Designer
Vintage
fig.06d-21-ps.eps
The chorus of the Vintage vocoder is applied separately from the patch effect named Chorus.
Parameter Value Description
Vocoder
EQ Low Freq
200–800 Hz Specifies the center frequency at which the low-frequency range will be
boosted or cut.
EQ Low Gain
-15– +15dB Specifies the amount of boost/cut for the low-frequency range.
Hi Cut Switch
OFF, ON Turns the high-frequency cut on/off. If you feel the sound is raspy, turn this
switch on to make the sound smoother.
Level
0–127 Adjusts the volume of Vocal Designer.
Attack
0–100 Specifies the attack time of the Vocal Designer sound relative to the mic input
sound.
Release
1–100 Specifies the release time of the Vocal Designer sound relative to the mic in-
put sound.
Consonant Level
0–127 Specifies the level at which the consonants extracted from the mic input
sound will be output.
Consonant HPF Freq
4500–9000
Hz
Specifies the frequency used when extracting the high-frequency components
from the mic input audio as consonants. Components higher than the speci-
fied frequency will be extracted as consonants.
Chorus
Vintage Vocoder Chorus Switch
OFF, ON This is an on/off switch for the chorus effect applied to the vocal sound.
Chorus Rate
0.05–10.0 Hz Adjusts the modulation frequency of the chorus effect.
Chorus Depth
0–127 Adjusts the modulation depth of the chorus effect.
Chorus Balance
D:0:100E–
D:100:0E
Adjusts the balance between the vocal sound and the sound with chorus ap-
plied.
Chorus HPF Cutoff
200–8000 Hz Specifies the frequency at which the high-frequency range will be cut.
Chorus Pre Delay
0.0–100 ms Specifies the delay time until the chorus sound is heard.
V-Synth-GT_e.book 157 ページ ２００７年４月９日　月曜日　午後１時４６分