Roland V-Synth GT Common (Settings Common to the Entire System)

196
System Mode (Settings Common to All Modes)
fig.08-02.eps_50
Common (Settings Common to the Entire System)
Master
Parameter Value Description
Master Tune
415.3–466.2
Hz
Adjusts the overall tuning of the V-Synth GT. The display shows the frequency
of the A4 note (center A).
Master Key Shift -24– +24 Shifts the overall pitch of the V-Synth GT in semitone steps.
Master Level 0–127 Adjusts the volume of the entire V-Synth GT.
Patch Remain
(Patch Remain Switch)
OFF, ON Specifies whether currently sounding notes will continue sounding when an-
other patch is selected (ON), or not (OFF).
*This function is valid only when the effect is turned off.
Also, when this is “ON,” changes produced by incoming MIDI messages
such as Volume (CC 7) or Pan (CC 10), as well as tonal quality and volume
changes produced by the various controllers will be inherited.
If you’re using AP-Synthesis, the sound will be interrupted when you switch
patches, even if the Patch Remain Switch is ON.
Startup Patch Last Patch When the power is turned on, the V-Synth GT reinstates the patch selected at
the time the V-Synth GT was last turned off.
Patch 001 When the power is turned on, the V-Synth GT will be ready to play Patch
“001.”
V-Synth-GT_e.book 196 ページ ２００７年４月９日 月曜日 午後１時４６分