12

USING THE UNIT SAFELY

fig.KD-8.e

1.

Remove the screws attached to the reverse side
of the KD-8’s trigger.

fig.KD-Assy01

2.

Pull out the stand in the direction indicated by
the arrow until it is fully extended.

fig.KD-Assy02

3.

Use a tuning key to tighten the screws removed
in Step

1

so that the stand is firmly secured.

fig.KD-Assy03

4.

Attach the kick pedal.

Position the beater so that it strikes the center of the head,
then secure the kick pedal and KD-8 firmly in place.

fig.KD-Assy04.e

Adjusting the Foot Plate Height

Depending on your kick pedal, it can be unstable when you
attach it to the KD-8. Be sure to adjust the foot plate height so
that the entire bottom surface of the pedal is attached to the
floor.

fig.KD-Assy05.e

KD-8

(Kick)

Making the Settings

Anchor Bolt
Head
Foot Plate
Stand
Output Jack
Install the kick pedal securely.
Beater
Commercially Available Kick Pedal
Beater
* Adjust the height so that the entire pedal comes
into contact with the floor.
TD-6KW_e 12ページ ２００６年１月２４日　火曜日　午後６時３分