Roland V-Tour TD-6KW Adjusting the Anchor Bolts, , When Using a Twin Pedal,

USING THE UNIT SAFELY

Loosen the stand’s anchor bolts and remove

the foot plate.

fig.KD-Assy06

Set the kick pedal so that the entire bottom

surface is attached to the floor.

In most cases, the stand becomes somewhat

floated. Tighten the anchor bolts securely there

to fix the stand and foot plate.

fig.KD-Assy07.e

• Install the kick pedal securely.

• Take care not to pinch your fingers.

• The tips of the anchor bolts are sharp. Handle with care.

• When moving the setup, be sure to remove the screws

and fold the stand. Transporting the KD-8 while it

remains open may subject the stand to excessive strain

and result in damage to the stand.

Adjusting the Anchor Bolts

When using the kick pedal on a carpet or similar surface,

adjust the anchor bolts so their tips protrude from the plate

and secure the pedal in place; this will make it easier to use the

kick pedal.

However, when used on flooring, the anchor bolts may

damage the floor. Adjust the anchor bolts correctly.

fig.KD-Anchor.e

The tips of the anchor bolts are sharp. Handle with care.

When Using a Twin Pedal

fig.KD-Pedal1

Position the two beaters

equally apart from the center

of the pad as shown in the

figure at left. If one of the

beater is further away from the

center than the other, the

sound from the further beater

will be lower in volume, or

will not sound as desired.

fig.KD-Pedal2

Using a twin pedal will result

in lower sensitivity as

compared to when a single

pedal is used. Raise the

sensitivity on the sound

module.

KD-8

Dimensions: 272 (W) x 260 (D) x 405 (H) mm

10-3/4 (W) x 10-1/4 (D) x 16 (H) inches

Weight: 2.9 kg

6 lbs 7 oz

Accessories: Screws

* Continuous playing may cause dis-coloration of the pad, but

this will not affect the Pad's function.

This hight will vary depending

on your kick pedal.

Specifications

When Using on the Carpet When using on the Floor

Adjusting the Anchor Bolts

TD-6KW_e 13ページ２００６年１月２４日　火曜日　午後６時３分