35
Panel Descriptions
29
Master Knob [MASTER]
Adjust the speaker volume or headphone volume of the
VGA-7.
* The setting of the master knob is not memorized.
30
Headphones Jack (PHONES)
Headphones are plugged in here.
* When headphones are connected, sound will not be output
from the speaker of the VGA-7.
* Before connecting or disconnecting headphones, you must set
[MASTER] to 0.
31
Power Switch [POWER]
Turns the power on/off.
* Before turning the power switch on/off, you must set
[MASTER] to 0.
Rear Panel
fig.41
32
Line Out Jacks
(LINE OUT L (MONO)/R)
These output the sound of the pre-amp, including the effect
section.
External devices such as a mixer can be connected here.
When using mono output, make the connection to the L
(MONO) jack.
33
EXT Input Jacks
(EXT IN L (MONO)/R)
These are stereo external input jacks.
External devices such as a guitar synthesizer can be
connected here.
The sound that is input will be output from the internal
speaker and from the headphones and line out jacks.
You can use the Master knob to adjust the volume.
When using mono input, make the connection to the L
(MONO) jack.
34
FOOT CONTROL
* If the plug is connected or disconnected while the power is on,
the effect on/off, patch, or manual/memory settings may change.
* When connecting the FS-5U/FS-5L (sold separately) to the
FOOT SW jack, set the polarity switch as shown below.
fig.91
Expression Pedal Jack (EXP PEDAL)
A separately available expression pedal (e.g., Roland EV-5 or
BOSS FV-300L) can be connected here.
The expression pedal can be used as a volume pedal to adjust
the volume of the VGA-7. However if the EFFECTS section
INSERT type is set to WAH, the pedal will function as a wah
pedal.
Rear Panel
32333435
Polarity switch