Roper Dishwasher installation instructions Congratulations

7,

To connect drain hose to an air-gap or waste-tee, cut end of drain hose as shown. Do Not cut drain hose when connecting to a disposer. Knock out plug from disposer Inlet. Secure drain hose with hose clamp provided. Do Not cu1 rlbbed sectlon lo shorten drain hose. Coil and tape extra drain hose under kitchen sink.

Product Damage

Do Not solder wlthln 6” of plastic water Inlet valve. Failure to follow this lnshuctlon could result In product damage.

Connect water pipe or tubing directly to water Inlet valve. Do Not run pipe or tubing across front of motor or dish- washer legs. Pierce a %” diameter hole through the sound shield [sound shield is not -&ailable on all models] for water line See Fiaure 8. Panel 8. Turn on water supply&d check for leaks

PANEL D

Make electrical connectlon or plug power supply cord into the grounded outlet.

CheckelectrIcal requirements.

Be sure you have correct electrical supply and recommended grounding method.

Remove all shipplng moteriols. Open dishwasher door: remove bottom rock. Place a newspaper or large sheet of paper over bottom of dishwasher to protect the pump area when securing dishwasher10 countertop.

11w

Secure dishwasher to countertop with two. No. 10 x %: PhilliDs-head screws from paris bog. You’MUST secure dishwasher to keep It from tilting when door is opened or closed Do Nof drop screws In dishwasher tub. If screws should fall Into the pump, pump and motor failure may occur. Remove poperfrom bottom of dishwasher.

Open door approximately 3” and check for equal spacing b&Men inner door ond tub sides. If necessary. loosen screws that fasten dishwasher to countertop and shift tub. Tighten screws.

Check	door	for proper-&ration.	Door
should close easily without slamming
and open with its own weight. If
necessary.		close door and adjust dooc
spring	with	pliers

14.

Take o few minutes to read the Use and Care Guide to fully understand your new dishwasher.

15.

Check that all parts have been installed and no steps were skipped. Check that you hove all the tools you started with.

16.

Turn on electric supply.

Start dishwasher and allow it to complete a cycle. Check that dishwasher is working properly and that there are no water leaks.

Replace the access panel.

You have just flnlshed InsstallIng your new Roper Undercounter

/DIshwasher.

( Congratulations! )

Keep Installa)lon lnshuctlona J \ a~llable for easy reference.