Roper RUD5000, RUD1000, RUD5750 Option Selections, Canceling a Cycle, Changing a Cycle or Setting

		Use this cycle for pre-					Use
LIGHT		rinsed or lightly soiled					covered
		loads.					detergent
WASH							dispenser
							section.
Wash	Rinse		Rinse	Main	Rinse	Final	Dry	Time	Water
				Wash		Rinse		(min)	Usage
									(gal/L)
								85	5.7/21.8
			●	●	●	●	●

Option Selections

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

Energy Saver Dry

Select this option to dry dishes without heat and save energy. The dishes take longer to dry and some spotting can occur.

OR

		Use this cycle for rinsing					Do not use
RINSE		dishes, glasses, and					detergent
		silverware that will not be					with this
& HOLD
		washed right away.					cycle.
Wash	Rinse		Rinse	Main	Rinse	Final	Dry	Time	Water
				Wash		Rinse		(min)	Usage
									(gal/L)
								20	2.9/10.9
					●	●

For best drying, use a liquid rinse aid. Some items (such as plastics) may need towel drying.

NOTE: Energy Saver Dry is an option with all cycles except Rinse & Hold (on some models).

Heated Dry

Select this option to dry dishes with heated air. For best drying results, use a liquid rinse aid and heated drying.

OR

Canceling a Cycle

You can cancel a cycle at any time.

1.Turn the Cycle Control knob slowly clockwise until you hear water draining. Let the dishwasher drain completely.

2.Open the door.

3.Turn the Cycle Control knob to OFF.

Changing a Cycle or Setting

If your dishwasher has more than one wash cycle, you can change a cycle anytime during a cycle.

1.Lift the door latch to stop the cycle.

2.Turn the Cycle Control knob clockwise.

3.Check the detergent dispensers. They must be filled properly for the new cycle.

NOTE: Turning the Cycle Control knob can cause the covered Detergent Dispenser section to open and release the detergent. Check the covered section if the cycle uses detergent in both sections.

4.Close the door firmly until it latches. The dishwasher starts a new cycle.

Adding Items During a Cycle

You can add an item anytime before the main wash starts, or the Cycle Control knob reaches Light Wash.

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2.Open the door and add the item.

3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle.

NOTE: Heated Dry is an option with all cycles except Rinse & Hold (on some models).

For Model 5750: To select Heated Dry, press RESET OPTIONS.

Low Energy Washing (model 5750 only)

Select this low energy washing option to reduce water temperature during the main wash and final rinse. This will reduce the amount of electricity needed to run the dishwasher.

NOTE: Low Energy Washing (model 5750 only) is an option with all cycles.

Reset Options (model 5750 only)

Select this option to change an option setting.

You can change option settings anytime during a cycle as long as the cycle has not passed the point where the option is used. For example, you can press Energy Saver Dry anytime before the Cycle Control knob reaches Dry.

1.Press RESET OPTIONS.

2.Press 1 or more options.

12