INSTALLATION
Installation
Please refer to the safety section first before proceeding with any installation or configuration of the CrystalView DVI Fiber.
When installing the CrystalView DVI Fiber, locate the transmitter as close as possible to the CPU or switch. Keep the cables as short as possible but still give some freedom of movement. You can mount the CrystalView DVI Fiber in a CPU rack with the optional rack mount kit. When mounting the units in a rack, follow the instructions in Appendix D and Appendix E. Provide adequate air circulation to assure that the maximum operating temperature is not exceeded.
For dual video models, connect a second DVI monitor and additional fiber cable from the transmitter to the receiver. The bottom Fiber connector on the Dual video models carries Video 1 and data, top fiber connector carries only Video 2.
Wherever the transmitter and receiver units are located, they should be on a secure surface and free from obstructions and objects that may cause damage to the units.
Fiber cable
TRANSMITTERRECEIVER
“Y” PS/2 Cable
LOCAL KVM | REMOTE KVM |
ACCESS | ACCESS |
Figure 1. Typical cabling configurations
(See Figure 1 for the connector locations for your model)
NOTE: Using the local access model, a second KVM station can be connected to the transmitter.
Refer to Figure 1 for the
6CRYSTALVIEW DVI FIBER INSTALLATION AND OPERATIONS MANUAL
