Wireless Adapter | User Manual | |
|
|
|
|
|
|
1.4 WIRELESS SOHO ROUTER DESCRIPTION
Rear Panel
Antenna | Antenna | Antenna |
|
Connector | Connector | Connector | |
SMA | SMA | SMA | DC JACK |
WAN | |||
| LAN: 4*RJ45 |
|
|
| 10/100/1000M |
|
|
WAN Port | DC Connector |
LAN Ports
Front Panel
WPS Button | Reset Button |
Power LED WLAN LED LAN 1- 4 LED WAN LED
Step | Label | Description |
1 | LAN Ports (1 – 4) | Use an Ethernet cable to connect each port to a computer |
|
| on your Local Area Network (LAN). |
2 | WAN Port | Use an Ethernet cable to connect this port to your WAN |
|
| router. |
3 | DC Connector | Use the power cable and connect the adapter to the power |
|
| socket on the wall, and the DC inlet into the DC connector. |
4 | Antenna Connector | Connect the three antennas to the SMA connectors. |
| Connection / | This LED will light up once an Ethernet cable is connected |
| Activity LED | to one of the LAN ports. |
| WAN LED | This LED will light up once an Ethernet cable is connected |
|
| to WAN (Internet) port. |
| WLAN LED | This LED will light up once the RF (wireless LAN) feature is |
|
| enabled |
| Power LED | This LED will light up once the power cable is connected to |
|
| the DC connector. |
| Reset Button | Use this button to reset the device. You can restore the |
|
| device back to its factory default settings by holding down |
|
| on this button for 5 seconds. |
| WPS | WPS (Wireless Push Button) is used for WiFi Protected |
|
| Setup. By pressing this button, the security settings of the |
6
