CD MULTI-DISC CHANGER RCC-955
External Remote Input 14 | Disc Skip Buttons 11 and 22 |
This connector is designed to be used in conjunction with Xantech™ brand Video Link™ IR signal pick ups (sold separately by custom system installers). This feature enables you to operate the
Video Link and Xantech are Trademarks of Xantech Corporation.
Remote Control Batteries
The supplied batteries must be installed before the remote control can be used. Slide the secondary control cover down until it stops. Then gently press the small triangular symbol on the cover and slide the cover down to expose the battery well. Install the batteries with the terminals as shown in the illustration in the bat- tery well. Test the control for proper operation, then slide the cover back into place. When the batteries become weak the re- mote control won’t operate the
Note: Remove the batteries from the remote control if it will not be used for a long period of time. Do not leave run down batteries in the remote control. Exhausted batteries can leak corrosive chemi- cals which will damage the unit.
The Disc Skip buttons have two functions. One is to turn the Disc Carousel when you are loading discs, as described in the previous section.
Note: Do not turn the carousel by hand; use the Disc Skip button. Do not touch the carousel while it is turning.
The other function of the Disc Skip button is to select a disc to be played. The next higher numbered disc is selected each time the Disc Skip button is pressed. If disc 5 is selected, pressing the Disc Skip button selects disc 1.
Pressing the Disc Skip button when a disc is not playing selects the next disc. If the Disc Skip button is pressed when a disc is playing, the
Selecting a Disc to Play
In addition to the Disc buttons described above, the remote con- trol may also be used to select discs.
Loading Discs
Disc Tray 5 and Open/Close Buttons 6 and 17
Press the Open/Close button on either the front panel or the re- mote control to open the Disc Tray. Place discs in the numbered recesses in the Disc Carousel with the label sides up. Be sure the discs are centered in the recesses in the Disc Carousel. Both standard 12cm disc and 8 cm disc may be loaded. There is a sepa- rate recessed area in the carousel for 8cm discs. When the Disc Tray is open discs can be loaded into the three disc positions at the front of the tray. To load discs into the remaining positions press the Disc Skip button 11 to rotate the carousel. Press the Open/Close button again to close the Disc Tray when you are done loading discs.
Note: Do not push the Disc Tray in manually. Doing so could cause damage. Use the Open/Close buttons. Do not touch the Disc Car- ousel while it is turning or attempt to turn it by hand, as this also could cause damage. Use the Disc Skip buttons and let the Disc Carousel come to a stop before loading or removing discs.
You can also load discs into the
Disc 1-5 Buttons 25 (remote only)
Press the button that corresponds to the disc you want to select. Pressing one of the Disc
Playing Discs
Play Buttons 7 and 19
Press the Play Button to play the disc indicated in the Disc Dis- play. The disc will begin playing with Track 1, unless another track has been selected before the Play button is pressed.
Unless one of the Repeat Play functions has been selected:
•After the last track on discs 1 through 4 is played, the next disc is selected and play continues with track 1 of the disc.
•At the end of disc 5 disc play stops.
See the Repeat Play section for more information.
8
