Rover Mowers Limited | Chip `N Shred | SAFETY INSTRUCTIONS |
Training
∙Become familiar with the Owner's Manual before attempting to operate this equipment.
∙Do not allow children to operate this equipment.
∙Do not operate this equipment in the vicinity of bystanders.
∙Carbon dioxide can be extremely dangerous in enclosed areas; do not run the machine in an enclosed area since the exhaust from the engine contains carbon monoxide, which is colourless, odourless, and tasteless.
∙Do not place hands or any other part of the body or allow clothing inside the feeding chamber, discharge chute, or near any moving part.
∙Before inspecting or servicing any part or the machine, shut off the power supply, disconnect the power cord or disconnect the spark plug lead from the spark plug, and make sure that all moving parts have come to a complete stop.
Preparation
∙Obtain and wear safety glasses and gloves at all times while operating the machine.
∙Avoid wearing loose fitting clothing. Operate the machine only on a level surface.
∙Do not operate the machine on a paved or gravel surface. Thrown objects could cause injury.
∙Before starting the machine, check that all screws, nuts, bolts, and other fasteners are properly secured. Replace damaged or unreadable warning and operator labels.
∙Use extra care in handling petrol and other fuels. They are flammable and vapours are explosive.
a.Use only an approved container.
b.Never remove fuel cap or add fuel with the engine running. Allow engine to cool before refuelling. Do not smoke.
c.Never refuel the machine indoors.
d.Never store the machine or fuel container inside where there is an open flame, such as a gas water heater.
Operation
∙Before starting the machine, make certain that the cutting chamber is empty.
∙When feeding shreddable material into the equipment be extremely careful that pieces of metal, rocks, bottles, cans or other foreign objects are not included.
∙If the cutting mechanism strikes any foreign objects or if the machine should make any unusual noise or vibration, immediately switch off the engine and allow the machine to stop. Disconnect the spark plug wire from the spark plug or remove power cord from power supply and take the following steps.
a.Inspect for damage
b.Replace or repair any damaged parts.
c.Check for and tighten any loose parts.
Do not attempt to repair the machine unless you are competent to do so.
∙Keep the engine clean of debris and other accumulations to prevent damage to the engine or possible fire.
∙Do not allow processed material to build up in the discharge area. This may prevent proper discharge and can result in kickback of material through the feed opening.
∙Keep all guards and deflectors in place and in good working condition.
∙Always stand clear of the discharge area when operating this machine.
∙Keep your face and body away from the feed opening.
∙Do not overreach. Keep proper balance and footing at all times.
∙Do not tamper with the engine governor settings on petrol engines; the governor controls the maximum safe operating speed and protects the engine and all moving parts from damage caused by over speed. Seek authorised service if a problem exists.
∙Do not transport this machine while the engine is running.
∙If the machine becomes clogged,
∙
Maintenance
∙When this equipment is stopped for servicing, in- spection, or storage, or to change an accessory, make sure the spark plug lead is disconnected from the spark plug, or the power cord is removed from power supply. Allow the machine to cool before making any inspections, adjustments, etc. Maintain the machine with care and keep it clean.
∙Store the machine out of the reach of children and where petrol vapours will not reach an open flame or spark. For extended storage periods, run the unit dry of fuel. Always allow the machine to cool before storing.
