Rover Domestic Rotary Mower Rear Catcher Mower SET-UP, Grass Catcher Fig, Folding Handle Fig

REAR CATCHER MOWER SET-UP

GRASS CATCHER (Fig. 2)

To Fit: Raise FLAP, grasp HANDLE, and position catcher against rear of mower.

To Remove: Grasp HANDLE, lift FLAP, remove catcher.

WARNING: Stop engine to fit or remove catcher.

FOLDING HANDLE (Fig. 3)

Your mower handle is held in position with either a LOCKING LEVER (Fig.3) or KNOBS (Fig. 4).

On Self-Propelled mowers the handles must be assembled when the mower is removed from the carton. Insert the threaded shank of the Locking Lever through the handle bars and secure with the nyloc nuts supplied.

If the handle will not lock in the mowing position when the LOCKING LEVER is pushed down, adjust NUT. Use 1/2” AF or 13mm AF spanner or socket. (Fig. 3).

CAUTION: Do not allow handle to fall to ground. Throttle cable damage may result.

Fold or unfold handle carefully and ensure throttle cable is not pinched or kinked.

Beware snags that may catch and damage throttle cable.

HANDLE HEIGHT

To adjust handle height, loosen NUTS and remove handle. Re- Tighten NUTS when handle is in desired position. Use a 1/2” AF or 13mm AF spanner or socket.

HEIGHT OF CUT (Fig. 5)

Apply outward pressure to disengage LEVER from RACK. Move lever forward or back to adjust cutting height.

4