4. MOUNT BOARD LAMINATING
**You can laminate photographs or pictures on a hard mounting board up to 2mm thickness**
1.Press the power button to turn on.
2.Temperature 130 and speed 1 is set for Foil function.
3. It is ready when LCD window shows | and the buzzor rings 3 times. |
4.Set material on Mount board then slide them into the opening slot
5.Finished board will exit through the rear slot of machine.
6.When finish, press the power button and turn off.
***USEFUL INFORMATION***
*The document, which has been mounting board laminated, is pretty hot and easily bent. Try not to touch the document until it has cooled down.
*When laminating to mounting board 2mm, pressure adjustment is needed for good quality lamination.
***LAMINATION PRESSURE ADJUSTMENT***
1.Unscrew 6 retaining screws of bottom and lift off top cover.
2.Locate each end of left and right pressure spring and set in the upper position, as shown.
3. Reassemble top cover with retaining screws and do lamination.
*For general lamination, set pressure springs to lower position.
15
