Using Cross Cutter, Loading Film | Royal Sovereign RSC-1400C

10. USING CROSS CUTTER

The cross cutter is located on the rear exit table of the machine.

1.After lamination, move the cutter approximately to the center of the completed application at the desired point of detachment (Figure 1).

2. Grasp film with one hand, press the cutter

downward into the application and slide it from one end to the other. (Figure 2 & 3).

Figure 1

Figure 2

Figure 3

RSC-1400C/H

Royal Sovereign films are wound with the adhesive side facing the inside of the roll (adhesive in).

Loading films to upper and lower film shafts:

(See page 5 for assistance with parts identification.)

1.Adjust the auto grip to fit to the film and tighten the auto grip screw (Figure 1).

Figure 1

2.Remove the upper and lower film shafts from the machine and load the films (Center the upper and

lower films on the shaft). Note the direction of the adhesives on the lower and upper films (Figure 2).

Figure 2

3.Load the upper and lower film shafts on the machine (Figure 3).

Figure 3