Royal Sovereign 1650C, RSC-1650H owner manual Laminating Steps, Reference

LAMINATING STEPS

1.Put cold roll film on upper bar.(Set the same as methord of the HOT film for protect paper of lower part)

2.Pull COLD film, and fix it so that backside protecting paper can be wound on take-up mandrel clockwise. (Revolve core to make protectingpaper tight a little bit.)

3.Set pressure lever at the proper position following to your lamination condition.

4.After pressing the RUN/STOP button choose and set proper speed by using the SPEED

button or .

5.Turn on the take up device and set the proper film tension by pressing the RUN/STOP button. Lower tension would make better operation.

10.Set pressure lever at the Hard board/15mm mode.

11.Turn off the power switch.

*** Reference ***

1.Set up the protection paper. Otherwise, glue form the film will be stuck on the face of roller and it can be seriously damaged.

2.Turn the switch RUN/STOP and “Take up motor” at the same time.

- 11 -